MX Gateway Documentation
- TT Gateway And The Exchange
- Installing And Upgrading
- Configuring Global Settings
Configuring Market Data
- Understanding the Price Feed
- Configuring the Price Server Connection
- HSVF Market Data Configuration
- Configuring the Price Server Connection 7.18
- Number of Orders at Price
- Support for Market Depth
- HSVF Market Data Configuration 7.18
- Calculating Volume at Price (VAP)
- Configuring Product Subscriptions
- Support for Settlement Prices
- Support for Implied Prices
- Configuring Order Management
- Configuration Parameters
- Disaster Recovery
To complete the MX Gateway installation, MX may request that you pass several connectivity tests with MX’s host machines. The customer must schedule specific dates and times with MX to perform these tests:
- Ping and Telnet Tests
- Price Server Startup Test
You perform these tests after configuring the TT Gateway (e.g., with NT User information, product tables, etc.), but before starting TTChron (refer to TT Gateway Architecture SAM Version 7.X).
Once you complete all tests with the MX, start TTChron; this service starts your Gateway as scheduled in ttchron.ini.
If this is a new membership (i.e., new TT customer), no one can trade through the TT Gateway until you successfully complete these tests.
Perform the ping and telnet tests to verify network connectivity to the MX host servers.
The MX distributes SAIL IP addresses that you must ping (labeled IPAddress in the procedure below). The MX usually sends this information via e-mail to their customers. There are two types of IP addresses that you may need to test (each type usually consists of a pair of IP addresses):
- TCP Replay Host
- Host Server IP addresses: Host Server IP Addresses are the IP addresses configured in the Order Server sections ([OrderServerSession_#]) of the hostinfo.cfg file. These IP Addresses provide access to the SAIL trading engine for order submission.
A ping test fails if the command window states the request has timed out.
To ping MX exchange host servers:
- Open a command window.
- Type: ping IPAddress1
- Type: ping IPAddress2
To troubleshoot ping connectivity:
- If you are unable to ping any of the machines at MX, verify that your network setup is correct. If your network is set up correctly, call MX.
- If you can connect to one but not the other IP address, call MX. The problem is most likely on their end.
MX distributes two SAIL order management IP addresses with its associated ports. TT recommends that you telnet these locations to test their status (respectively labeled IPAddress and Port in the procedure below). MX usually sends this information via e-mail to their customers.
To telnet MX:
- Open a command window.
- Type: telnet IPAddress1 Port
- Type: telnet IPAddress2 Port
The telnet test fails if you receive a Connection Failed prompt box.
Testing Price Server Setup
For best results, execute this test while the Price Server is running, and not outside of the default TTChron hours.
To start the Price Server:
- If TTChron is configured to shut
down the Price Server during the time that you run this test, stop
the TTChron service.
For this procedure, refer to the TT Gateway Architecture SAM Version 7.X.
- From the Start menu, point to Settings, and then click Control Panel.
- Double-click Administrative
The Administrative Tools window displays.
- Double-click Services.
The Services window displays.
- Scroll through the Services window to locate TT Price Server.
- Right-click TT MX Price Server, and
then click Start.
After about thirty seconds, the Price Server in Guardian should display as green.
To troubleshoot connection problems:
- Run the TT Listen tool to verify whether the connection is working.
- Check the command window or:
- Make sure that the command is pointing to the correct file.
- If you see the text “Connected” followed by the text “Disconnected”, notify the MX. They will need to assist you in diagnosing the cause of this error.