TOCOM Gateway Documentation
- TOCOM Gateway And The Exchange
- Installing And Upgrading
- Configuring Global Settings
- Configuring Market Data
- Configuring Order Management
- Configuration Parameters
- Configuration Parameters: Multi Member
- Accounts And Sub Accounts
- Disaster Recovery
The TT Gateway installation package distributed by TT includes an Exchange-provided login test tool utility: apitstlogin.exe. This utility installs in <root drive>:ttExchange-Flavor. You must run this executable from a command prompt.
Prior to running the login test tool utility, ensure that no one is logged in using the userID you wish to test with. If the test is completed with a userID that is in use, you will successfully log into the Exchange, but the trader will be logged off.
To test API login
- On the Start menu, point to Programs, and then click Command Prompt.
- Type: apitstlogin.exe UserName Password Gateway
- UserName is the trader’s userID.
- Password is the trader’s password to connect to TOCOM.
- Gateway is the IP address of the TOCOM Gateway.
Port is the port number of the TOCOM Gateway.
Example API Login Test
apistslogin.exe TT031P23 4cdt3 220.127.116.11 5001
Failed Connectivity Test
If the connectivity test fails, you will receive the following message: Error (-2012) Reason: system error occurred on ‘connect’
If you receive this message, check the command line for incorrect typing. Alternatively, the Exchange host may be down or off-line.
Contact the Exchange if you are unable to perform a successful connectivity test.
Successful Connectivity Test
If the connectivity test is a success, you will receive the following response:
Example Successful Connectivity Test Response
C:ttTOCOM> apitstlogin.exe TTO31A23 4cdt3 18.104.22.168 5001
Logging in user.. Success
Getting user info.. Success
Country ID: SG
Getting facility id EP0.. Success
EP0 Facility 720
Logging out user..
Closing API session..
Once your connectivity test is successful, the UserName, Password, Gateway, and Port may be used in the Exchange-Flavorhostinfo.cfg as TTO, TTP, or TTF settings.